CONTACT primer
The primer is designed for priming dense, non-absorbent mineral surfaces (concrete, ceramic blocks, etc.) before applying decorative or levelling plaster or laying tiles, as well as for priming old tiles before re-gluing them. It is used to improve adhesion before gluing plasterboard sheets. The primer contains quartz sand fillers.
SURFACE PREPARATION: The surface to be treated must be dry, clean and free of grease. Fresh concrete surfaces can be primed after 14 days at the earliest.
INSTRUCTIONS FOR USE: Stir the primer thoroughly before and during use. Apply the primer with a brush, roller or sprayer. If necessary, the primer can be diluted with water. The ambient temperature must not be below +5 °C.
COVERAGE: approximately 0.25-0.30 kg/m².
SETTING TIME: setting time 1-2 hours. Plaster can only be applied after the primer has dried and is no longer sticky.
STORAGE: Store in the original packaging at a temperature above 0ºC for approximately – see label. Do not allow to freeze. Mix thoroughly before use.
Hazard categories: –
Signal word: –
Contents: –
Product exposure characteristics: –
Safety requirement symbols: –
Additional labelling: P102-Keep out of reach of children.
